The front bubble part of the canopy is supplied ready formed but the rear has to be formed out of scap sheet acetate.I achieved this by cutting roughly to size then moulding it round te canopy frame with careful use of a heat gun and glued in place as shown.
The hatch is held in place with the use of a short piece of dowel at the front and a magnet catch at the rear. The frame detail on the canopy is achieved with a silver paint pen.
The wing can be permanently glued in place but I chose to make it removable using a single wing mounting bolt at the rear of the wing and a short length of dowel at the front,
.
I used a standard control horn a brass linkage soldered to the control rod.
The COG is quite easy to achieve moving the Lipo forward or back.
I was surprised to find no form of ventilation for the cooling of the motor train.
I have made small openings in the nose top and bottom and a opening underneath the small faring on the fuselage side, leaving a narrow gap behind the trailing edge of the wing to provide some cooling ventilation.
Nice looking small model 
.
denotes 
.
. 
