PAUL HUTCHINSON 2

Hi Ed, thanks for the advice. I’ve fitted the existing needle valve and the new needle valve housing to the carb body and it all works fine. Fantastic advice as always on this forum!!!!

Flip, really I actually didn’t know that lol. I will try that at the weekend when I’m home again. Really appreciate ur advice

Cheers Engine Doctor, let me know if you find a spare. The needle valve assy part number I need is EVO040874 Outrunner - I knew when I bought it that there was an issue with the needle valve assy.

Thanks guys, perhaps I didn’t explain myself very well. The needle valve I have does not fit into the carb body it’s as if the outer diameter of the needle valve is too big to fit into the body. My question was if I can’t find spare parts are there any aftermarket assemblies that can be fitted to replace the original one. Cheers Paul

Hi guys, I've just purchase a 2nd hand Evolution 60 engine (on ebay) and the remote needle valve does not fit into where it used to. It look as if someone had modified it for a specific model, does anyone know where I could get a new one or fit an aftermarket replacement?

Ok looks like I'm gonnna go with the 363, will order from Sarik. Thanks for all the help and comments, great to have so much help!!

Thanks Guys, I will have a look at them all. Paul

Hi guys Can anyone recommend a good delta wing that flies well and runs on brushless/lipo. I'm looking for a new building project that can be built from plans that are comercially available. Many Thanks Paul

That’s a fantastic idea, what did u use to stick the bulkhead to the front of the fuselage? cheers paul

Thanks guy's, great to see sooooo much help and advice

Guy's just thinking, I have some 5 minute araldite epoxy and other 5 minute epoxies would they be as good at sticking the EPO foam? I will test a small area first but wanted your opinion first Sorry for all the questions Paul

Thanks Ray, appreciate your help

Guy's can you advise what you would use if the whole motor mount had ripped the front of the foam e out after a rough landing. Would uhu/gorilla glue/super glue be ok? If gorilla glue, which one would you recommend? Cheers Paul

Guys has anyone put a brushless motor into these yet? I reserrecting (if thats correctly spelt) and old one Ive had for years and looking to fly it again. I used to run it on the old masterairscrew 550 motor and gearbox but I remember it was real nice to fly. Thanks for your help Paul

Guys any ideas on what glue to use to stick the motor mount and front of the Wot4 FoamE with, had a bit of a heavy landing and broke the front of the plane. I know to use the Foam to Foam glue for the foam parts, but what to use to stick the metal motor mount to the Foam with? Thanks for your help Paul