codepox
Members-
Posts
17 -
Joined
-
Last visited
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
codepox's Achievements
5
Reputation
-
Thanks, I did not know it was called with a different name in the USA.
-
Does anyone knows how to buy and have the RCM&E May issue shipped to USA?
-
After reading the all thread, I have compiled this list of errata building from the plan, hope this helps other also. - Head support brackets (Tongues) Birch Ply wood preferred over Lite Ply - Left/Pitch servo lower by ~5mm, mounting lugs too close to Lower Mast Support - Hatch Base H3: 20mm too long, side view is correct - Pivot head hole 15mm from the top instead of 20mm, side view is correct - Under Carriage aluminum drill hole 30mm from center, 35mm on the plan is incorrect - Engine right trust 2 degrees not mentioned on the plan - On the side view, the labelling of LMS1 and UMS2 are reversed
-
I found this post on page 10:
-
I read in the thread that the left/pitch servo needs to be lowered. Has someone a picture or can describe the problem? Does the servo needs to move to the right or just down, by how much? Thanks
-
The shaft is 1/4", is the smaller version more appropriate for the panther, do you have a part number or a picture of the smaller version? I am looking for aluminum for the undercarriage, 6082 seems hard to find here in the USA, is 6061 OK?
-
I bought this Astroflight gearbox on Ebay, it was sold a 710 Superbox, is it the right gearbox to build a panther?
-
Yes, you are correct Model Aviation Magazine is published by the AMA which is the American Model Association. This is awesome that the Revolver II gets featured in the magazine.
-
Covering is mostly done, still need to add the name next time I have access to my friend vinyl cutter. Next step will be to do the canopy then electronics install. What a beautiful design, I am really enjoying this build.
-
Yes, the short kit from Sarik came with the canopy
-
Wood work is pretty much done, soon will be time to start the covering
-
codepox started following Richard Harris
-
Thanks, so looks like theses blades should be fine to get started. I'll make another set of lighter ones using Richard's method. Latest progress on the revolver
-
I am using blades made by Astik Models, there are very nicely built and came pretty well matched, all within 0.6g. There are a little bit narrower, 55mm instead of 60mm so I cut them 10mm longer to compensate. The leading edge hardwood section is bigger than the one recommended on the plan so because of that they are heavier: 54g finished instead of 40g Is this going to be a problem?
-
Some progress.
-
Outrunner, thanks for your reply and interest. I will continue to post photos as my build progress.