EarlyBird Posted January 26 Author Share Posted January 26 The treatment starts with a sharp knife for a bit of whitling. A few big bits. Then I used my plane to get a rough size, making sure not to go too far. A bit more plane, I think. That's close enough with 1/16" at the bottom and just not touching the top leaving it at 5/16" Next, I held it in place on the TE for a close shave with the plane. That will do nicely. After a bit of sanding. It's ready for the TE to be cut off (98 mm) and glued. Leaving the remainder for the aileron. That's next then fit the hinges and finish the wing tips. Steve Quote Link to comment Share on other sites More sharing options...
EarlyBird Posted January 27 Author Share Posted January 27 I thought the aileron was finished but on moving a clamp from the en to the centre. Just more plane and sanding led to this. That's better. Steve Quote Link to comment Share on other sites More sharing options...
EarlyBird Posted February 1 Author Share Posted February 1 One wing, at last. 👍 I can now put this build on hold while my mate John catches up. Onto Peggy Sue II for a while. Steve 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.