Ariel Posted April 6 Share Posted April 6 Very happy with my Ender 5 S1 with the Klipper Sonic pad. Depends a lot on what you want to do but the Ender is less expensive than the Bambu labs printers and works fine for my requirements. Even with Klipper 3D prints are measured in hours rather than minutes. Quote Link to comment Share on other sites More sharing options...
Keith Billinge Posted April 6 Share Posted April 6 (edited) Buy some silicon rubber spring substitutes and once you dial them in, they stay dialled. No more problems levelling the bed. Buy Here Edited April 6 by Keith Billinge Quote Link to comment Share on other sites More sharing options...
EvilC57 Posted April 7 Share Posted April 7 8 hours ago, Keith Billinge said: Buy some silicon rubber spring substitutes and once you dial them in, they stay dialled. No more problems levelling the bed... Thanks Keith, hadn’t seen those before. They look like they might be the answer to the bed drift problems on my Ender 3 V2. I have the supposedly upgraded yellow springs which were OK for a while, but I suspect may be the cause of my recent levelling problems. I’ll get some on order… Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.