Maurice Dyer Posted March 16, 2021 Share Posted March 16, 2021 I don't have a programme card and I'm not sure what I set the low voltage cut off too. The question is this: when my 4s gets down to about storage voltage (15 .4 ish), you cannot throttle up any more. So how do I start again as if it's the first set up on this model ??. Motor is 3540 thumped running a 12 by 6 all leccy prop. Quote Link to comment Share on other sites More sharing options...
EarlyBird Posted March 16, 2021 Share Posted March 16, 2021 The manual is here ESC_Manual.pdf (overlander.co.uk) Cheers Quote Link to comment Share on other sites More sharing options...
Maurice Dyer Posted March 16, 2021 Author Share Posted March 16, 2021 Thanks steve, I have the manual, but how do I enter the programme mode to change something ??. Once the ESC is in the model and set, how do you get back into programming ??? Cheers Quote Link to comment Share on other sites More sharing options...
EarlyBird Posted March 16, 2021 Share Posted March 16, 2021 Quote Link to comment Share on other sites More sharing options...
Maurice Dyer Posted March 16, 2021 Author Share Posted March 16, 2021 9 minutes ago, EarlyBird said: Thanks you Steve; I didn't realise this. If in doubt , read the instructions...…. Quote Link to comment Share on other sites More sharing options...
EarlyBird Posted March 16, 2021 Share Posted March 16, 2021 ? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.