Jump to content

Two esc's using both bec ciruits


Mick Baker
 Share

Recommended Posts

Just read the article in RCM and E July edition re the  concord one model, on pade 31 there is reference to a throttle ESC mixer that uses diodes which permits all the bec's to be used without shorts etc, can anyone point me in the direction of the circuit diagram/veroboard cuts.

Cheers, Mick

16296604431305492656330901720097.jpg

Link to comment
Share on other sites

The circuit is very simple I think, just needs one cut for each diode on the + wire of each ESC. The receiver goes to the three pins at the top, the ESCs are side by side at the bottom. The first ESC is basically straight down, the second ESC has the three short yellow wires to step across the board by three lines, etc. Each ESC central + connection has a diode in series, pointing from ESC to receiver. The trace in the stripboard just needs cutting under each diode.

 

What I don't know is which Schottky diodes would be appropriate. You need high current and low voltage drop ideally.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...