Here is a list of all the postings NigelH has made in our forums. Click on a thread name to jump to the thread.
|Thread: Another forum hacked|
What was it warning about ? A specific threat ?
I got mine today.
|Thread: HOBBYKING SITE GONE OR DOWN ???|
I think that this is probably due to yesterday's GoDaddy issues. Too much of a coincidence.
|Thread: Glitches when using 35Mhz with electric|
I've no experience of it but every review has five stars. May be worth looking at in more detail.
Looks like you were the only person to read what the OP said. I just commented on what someone else said
If it's this Wot 4e as opposed to an electrific 'normal' Wot 4 then the S3003s will not be suitable.
As you say, mini servos are in order in that case. Also, there's another thread about this model.
|Thread: Low-cost digital tachometer|
We were typing at the same time. I picked GBP as it's more meaningful even if it is likely to vary slightly, as suggested.
Showing at £7.36 plus postage but that may vary depending on the exchange rate.
Agreed but watch out for the copies though. According to comments on here, those have white output shafts and the mounting lugs are 'slotted', not 'holed'.
|Thread: Follow on plane after Wot4 (to suit Magnum 70 FS)|
Either of those.
Or the dreamy Toledo Special.
|Thread: Low-cost digital tachometer|
HK just got these in today at their UK warehouse. I've no experience of it but there will be reviews on the main warehouse item.
|Thread: New Poll - Has the recession had an impact on your hobby?|
Ok, just seen the watermark
Which Cub is that ?
|Thread: Feels like autumn is approaching, what have you been flying?|
Ok, so the weather's been pants all year but tonight, it looks like I may get in a couple of flights. After a walk down to the field to check the conditions, I walked back for the TX and my PZ P47-D.
I stepped outside, hooked the DX8 onto the metal clip on the strap only to watch it immediately drop to the floor and bounce from the tarmac onto the grass, the strap still around my neck. The metalwork was attached to the TX.
I can't see any marks on the outside. There is a slight noise from within the TX when I shake it. I don't know if that's normal.
I took it down to the field and did a range check with the AR600 in the BNF P-47D and only got to fifteen paces (not even full yards) before the model would not respond to the controls on reduced power. The model was on the grass with the gear up with the RX as PZ installed it. To be honest, I probably never did a range check with the model but today's tests suggest that things aren't right and that maybe my TX is bust ?
Someone on HelFreak experienced the same thing with his TX dropping off the strap. Never had that issue with my Futaba one.
|Thread: Ebay sellers...|
Are you sure that you couldn't use the 'EXCHAUSTS ' ?
|Thread: OrangeRX 3-Axis Flight Stabilizer|
My ORX arrived yesterday. I was thinking about putting it in my PZ P-47D but when I pulled the hatch, I realised that I'd over-estimated the amount of free space in there.
I was also thinking about putting it into a Bixler with a load of LEDs on it. That sort of plane ought to make a good winter model to help make up for a very sparse Summer flying season.
Edited By NigelH on 30/08/2012 09:38:57
|Thread: Transmitter Quality|
Welcome to the forum.
I don't know the TX but there's advice here that suggests that 100m is all you can rely on.
That's not very far and you also mentioned going faster so maybe this isn't going to be up to it.
Edited By NigelH on 29/08/2012 23:05:38
|Thread: Photo Insert Disabled?|
If you're using IE 9 then be sure to enable compatibiliy mode as you wil have issues with this site if you don't.
|Thread: Nats 2012 photos and chat|
What did you buy ?
|Thread: Show us your bargains from the NATS 2012|
Which Hangar 9s ?
That Flair's a beauty but he's not glued the vertical stab and rudder where they need to be
Want the latest issue of RCM&E? Use our magazine locator link to find your nearest stockist!