|Anthony Pratt 1||10/10/2018 11:04:30|
|4 forum posts|
Trying to find an adhesive to attach a hard plastic motor mount into an EPO fuselage. Any ideas please. Tony
|Biggles' Elder Brother - Moderator||10/10/2018 11:26:08|
15748 forum posts
Mmmm, that's a tricky one! It's obviously going to be a stressed joint so its has to be good and TBH I wouldn't be 100% confident in any bond because the underlying EPO isn't that strong!
If there was no alternative and I had to do it I'd probably think in terms of well keying the plastic with some sandpaper then using perhaps epoxy or maybe Gorilla glue. But its a joint I'd want to keep a very careful eye on for some time once in use.
PS How big a motor are we talking about?
Edited By Biggles' Elder Brother - Moderator on 10/10/2018 11:27:09
|Former Member||10/10/2018 11:29:29|
[This posting has been removed]
|Denis Watkins||10/10/2018 11:51:25|
|3804 forum posts|
You need to add some 90° prongs to the motor mount Tony
I used 1/8th diameter, 1" long aluminium rivets,
Embeded into the motor mount
pushed into the foam, into pre hot melt holes, drilled with a hot rod
The whole lot is then pushed in using araldite or your favourite glue
1391 forum posts
The foam will flex. The motor and CA glue will not.. I have never used silicone sealer with foam, but it might be a good long-term solution. Clean surfaces well first to remove any oil or grease.
Edited By Plummet on 10/10/2018 11:57:30
|Martin Harris||10/10/2018 12:12:12|
8732 forum posts
Perhaps a picture of the job would help? Adhesives normally work best in shear so some mechanical support (as per Denis' suggestion) may be the answer. It would also help to know what type of "hard plastic" is involved.
|Anthony Pratt 1||11/10/2018 08:27:41|
|4 forum posts|
Thanks Guys that gives me some ideas to work to. Having now cut the top off the fuselage the motor mount has a raised ring around the outside which locates in a moulded recess in the fuz. this has now become enlarged in places allowing the mount to rock. Now the dog can see the rabbit as they say. thanks again. Tony
|Gordon Tarling||11/10/2018 10:32:29|
|231 forum posts|
Foam-Tac is the adhesive to use for sticking almost anything to foam. Available from the usual online sellers, though it's not cheap.
|Bob Cotsford||11/10/2018 12:12:55|
7926 forum posts
I have used Gorilla glue in my Wot 4 and Acrowot foamies to take up the slop in motor mountings. Don't overdo it or it will expand to fill any voids it can find including the back of the motor, battery spaces and the like!
Please login to post a reply.
Want the latest issue of RCM&E? Use our magazine locator link to find your nearest stockist!