By continuing to use this site, you agree to our use of cookies. Find out more
Forum sponsored by:
Forum sponsored by CML

How do you clean your glow engined models after flying?

All Topics | Latest Posts

Search for:  in Thread Title in  
Jonathan M17/09/2020 17:43:00
avatar
853 forum posts
321 photos

I don't mind the faff of cleaning glow-fuel residue off IC models after flying before packing them away in the car, but wondering what the easiest/best method is?

Been using baby-wipes (never been without them since the kid was a nipper fifteen years ago!). These seem to lift most of the gunk off, then I wipe the surfaces dry with some kitchen-roll tissue.

But is there a better method - what do other people do, or what products do you use?

jrman17/09/2020 18:01:33
423 forum posts
3 photos

I use "Rhino Goo" from Demon Tweeks. I'm sure similar products are available elsewhere but they sometimes do 2 x 5 l for the price of 1. I use it diluted 50% with water and it works extremely well, also good in an ultrasonic cleaner for engine parts.

i12fly17/09/2020 18:31:27
avatar
649 forum posts
22 photos

Kitchen non-ionic surfactant spray or Furniture polish. Only a light spray required. The cheapest is as good as any.

The former if really gooey but the latter gives a nice finish on glossy film.

Doc Marten17/09/2020 18:38:17
avatar
889 forum posts
18 photos

Tissue and baby wipes for me.

Richard Acland17/09/2020 19:24:46
avatar
141 forum posts
70 photos

I have a spray bottle of water and washing up liquid mix which I spray on and then wipe off with kitchen towel. takes a couple of minutes and my model ends up gleaming.

Mark H7517/09/2020 19:25:04
avatar
13 forum posts

Just normal glass and cleaner nowadays; I've tried various concoctions and ratios including meths, Isopropyl, washing up liquid etc, but glass cleaner seems to to the job. I use blue roll paper as I buy it in bulk for use around the workshop.

Edited By Mark H75 on 17/09/2020 19:39:48

cymaz17/09/2020 20:35:53
avatar
9396 forum posts
1217 photos

I use these...because I can get them cheap at work.

Also this is a great degreaser

Martin McIntosh17/09/2020 20:54:19
avatar
3582 forum posts
1233 photos

Flash or Tescos hard surface cleaner is only £1 a bottle and diluted 5:1 not only cleans off the oil but gets rid of the smell as well.

Zflyer17/09/2020 21:34:33
45 forum posts
2 photos

Elbow Grease £1 a bottle and/or Elbow Grease wipes. (Dont know if the latter are enviroment friendly)

J D 817/09/2020 21:59:58
avatar
1631 forum posts
87 photos

Spray of Fairy ready mixed in water and kitchen towel.

ASH.17/09/2020 23:51:23
avatar
337 forum posts

Tesco Anti+Bac lemon multi-suface wipes. Works wonders. Try it.

Doctor Chinnery18/09/2020 00:14:47
76 forum posts

Used to be old (v.v. old) Terry Towelling nappies, now tired (v.v. tired) old hand towels or old tea towels to wipe off the worst of the grott, Anyway you need one after starting and tuning your engine before you fly and again after carirying your pride and joy back to the pits after a flight. I then wrap the engine and silencer in one of the grotty towels to prevent oll stains in the car on the way home. When I get home it could be whatever spray SWMBO has in the kitchen for cleaning surfaces that day or alternatively automobile glass cleaner spray as supplied in the usual pump sprayers (Auto Glym is excellent) any of which will shift pretty well anything that's likely to be stuck to your airframe. The secret, whatever cleaning fluid you use is to remove it with a clean towel and as a final flourish polish with another clean cloth. As mentioned above - a homeopathic misting with your furniture polish of choice at the polishing stage is the finishing touch, or overkill depending on your point of view.

As a last resort diluted washing up liquid or screen wash will also do the job, but not up to the standard of the dedicated automobile glass cleaner.

Finally - in the cause of marital harmony - don't try to sneak your 'flying' towels in with the family wash -

Nigel R18/09/2020 06:38:31
avatar
4201 forum posts
703 photos

Old t shirts.

Household glass cleaner spray.

Wash t shirts every so often. By themselves, as noted above.

Tim Flyer18/09/2020 07:13:44
avatar
1337 forum posts
239 photos

I keep an industrial blue paper towel roll in the car and use a quick spray of mr muscle kitchen and bathroom cleaner which immediately removes any traces of oil. Very quick! My planes are stored hanging horizontally from the garage ceiling and I put a “nappy” of the paper towel round the cowl to prevent oil dripping out onto the floor later on. 

Edited By Tim Flyer on 18/09/2020 07:17:14

Edited By Tim Flyer on 18/09/2020 07:18:51

leccyflyer18/09/2020 07:23:44
avatar
1637 forum posts
339 photos

Used to use Jif Mousse and pretend that I was laying down a foam blanket following an emergency landing, Then again I murmur takka-takka-takka under my breath every time my FW190 swoops down on the field.

Can't say that I miss that clean-up routine.

Engine Doctor18/09/2020 09:16:25
avatar
2629 forum posts
40 photos

I use the spray windscreen de-icer . It contains high amount of alcohol that cuts through oil and leaves models clean without being sticky like some baby wipes that I've seen being used. I also buy cheap tea towels for the cleaning and after a few rinses replace them. Buy the de-icer during the summer when cheaper or 2 for 1 . You can buy the de-icer in gallons or half gallons if you have an old spray bottle handy.

Jonathan M18/09/2020 09:25:42
avatar
853 forum posts
321 photos

Windscreen de-icer is a good idea - ordinary de-icer spray bottles advertised as "down to -15 C" or "down to -40 C" etc? 

Edited By Jonathan M on 18/09/2020 09:41:57

Peter Christy18/09/2020 09:47:58
1910 forum posts

Muc-off - followed by mechanics paper towels.

Muc-off is also good for cleaning trannies without affecting the plastic!

--

Pete

Cuban818/09/2020 09:49:41
3062 forum posts
1 photos

50:50 Elbow grease and water does the job as well as any of the 'witches brews' I've tried over the years. Cheap as chips from Poundland and lasts for ages. Similar to the excellent Desolve-it that we used to use in work but much more diluted.

Use Muc-off on my motorbike, good for very heavily oiled models now and again when required, but quite expensive for use after every flight. Usually around a tenner a bottle but sometimes on offer for less than half that. Can be diluted.

 

Edited By Cuban8 on 18/09/2020 09:55:44

Tim Flyer18/09/2020 11:03:58
avatar
1337 forum posts
239 photos

For transmitter cleaning mr sheen multi surface polish is great ... removes oil and leaves them like new.

All Topics | Latest Posts

Please login to post a reply.

Latest Forum Posts
Support Our Partners
Slec
electricwingman 2017
CML
Sussex Model Centre
Sarik
Advertise With Us
Latest "For Sale" Ads
NEW POLL - has the pandemic altered your event safety perceptions?
Q: Has the covid pandemic deterred you from attending shows and events in 2021?

 No, I'll be attending just as many as I usually do
 No, but I'll choose my event with greater care
 Yes, I'll attend fewer events going forward
 Yes, I wont attend any where previously I have

Latest Reviews
Digital Back Issues

RCM&E Digital Back Issues

Contact us

Contact us

Magazine Locator

Want the latest issue of RCM&E? Use our magazine locator link to find your nearest stockist!

Find RCM&E!