broken flex coupling
|robert chamberlain||06/09/2013 09:00:32|
|121 forum posts|
The flex coupling on my Dremel has come apart. For some reason, this part is not shone in the parts diagram nor is it listed in the Parts section.This is the rubber like tube, located inside the tool, which connects the motor to the output shaft. It is 1 inch long and 3/8" OD with a splined 5/16" ID hole.Searching on line has come up with too many different part numbers and, of course, my model 595 does not ever show up at all. I took a wild guess and ordered one, to arrive next week, but if it does not fit are there any ideas out there on an easy subsitution? Well, I'll admit it is 30 years old so not too bad, concidering. Bob C in Kansas
Please login to post a reply.
Want the latest issue of RCM&E? Use our magazine locator link to find your nearest stockist!